Standards
Within the general scope defined in Section I, ANSI/ASME B30.17 applies to overhead and gantry cranse with a top running bridge, of single-girder construction, utilizing one or more underhung hoists (see ANSI B30.16) operating on the bottom flange of the bridge girder. This Standard includes both power-driven and hand-operated equipment.
This standard specifies requirements for bread and rolls and methods of test for these requirements.
This standard specifies requirements for bread including buns and rolls and methods of test for these requirements.
This standard specifies construction, operation, safety requirements, labelling and tests for domestic gas stoves with metallic bodies intended for use with liquefied petroleum gases at 2.452 to 3.432 kN/m2 (or equivalent) gas inlet pressure.
This standard specifies physical dimensions, performance and marking requirements for pneumatic tyres for highway commercial vehicles. Test methods for determining conformity to the performance requirements are also included.
The requirements cover television equipment intended for household and commercial use on supply circuits in accordance with the National Electrical Code, NFPA 70.
This standard specifies requirements for two grades of unleaded gasoline in Guyana for use in motor vehicles with spark-ignition internal combustion engines. It also specifies a method for determining adulteration of premium gasoline with regular gasoline.
This document contains the standards governing TV broadcasting systems. The standards ensure satisfactory monochrome and colour television broadcasting services based on the 525-line NTSC colour system. The system is known as NTSC/M
This standard specifies requirements for hollow blocks made from fired clay. The standard covers the general quality, dimensions and strength of the blocks.
This standards covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.