Standards
This European Standard specifies a method for determining the flex resistance of outsoles. This method is intended to assess the effect of sole materials and surface patterns on cut growth. This method is applied to outsoles that, in accordance with the test mentioned in Clasuse6, have a maximum longitudinal rigidity of 30 N.
This European Standard specifies the sampling location, preparation and duration of conditioning of samples and test pieces for footwear components and footwear, to carry out the test methods needed to determine the suitable properties for the end use.
These are the general conditions unless otherwise stated in the corresponding test method.
This document describes a test method for determining the resistance to separation of the upper from the outsole, for separating adjacent layers of the outsole or for causing tear failure of the upper or the sole. It also defines conditions of ageing that can be used for production control.
This document is applicable to all types of footwear (cementing, vulcanisation, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembled (closed shoe).
NOTE 1 In all cases the objective is to test the bond strength nearest to the edge of the assembly.
NOTE 2 The test need not be carried out when the bond has been made by grindery (using, for example, nails or screws) or stitching.
This Standard describes a test method for the determining of the resistance to separation of the upper from the outsole or to separate adjacent layers of the outsole or to cause tear failure of the upper or the sole is measures. It also defines conditions of aging that can be used for production control. It applies to all types of footwear (cementing, vulcanization, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembles (closed shoe).
This document specifies a method for the determination of the abrasion resistance for outsoles,
This document specifies three methods for determining the shape retention properties and compression strength of a doomed test specimen.
This part of ISO/IEC 9314 specifies the Media access control (MAC) , the middle sublayer of the data link layer (DLL) for fiber distributed data interface (FDDI) .FDDI (ISO/IEC 9314) provides a high -bandwidth (100 Mbit/s).general - purpose interconnection among information processing systems, subsystems and peripheral equipment , using fiber optics or other transmission media. FDDI can be configured to support a sustained data transfer rate of at least 80 Mbit/s (10 Mbytes/s). FDDI provides connectivity for many nodes distributed over distances of many kilometers in extent . Certain default parameter values for FDDDI (e.g. timer settings) are calculated on the basis of up to 1000 transmission links or up to 200 km total fiber path length (typically corresponding to 5000 nodes and 100 km of dual fiber cable, respectively), however, the FDDI protocols can support much larger networks by increasing these parameter values.
This part of ISO/IEC 18026 provides an overview of different techniques of security gateways, of components and of different types of security gateway architectures, it also provides guidlines for selection and configuration of security gateways.
This part of ISO/IEC 20000 defines the requirements for a service provider to deliver managed services of an acceptable quality for its customers