Standards
This European Standard specifies a test method for assessing the tear strength of upper, linings and insocks or complete upper assembly, irrespective of t material, in order to assess the suitability for the end use.
This European Standard specifies a method for determining the flex resistance of outsoles. This method is intended to assess the effect of sole materials and surface patterns on cut growth. This method is applied to outsoles that, in accordance with the test mentioned in Clasuse6, have a maximum longitudinal rigidity of 30 N.
This European Standard specifies the sampling location, preparation and duration of conditioning of samples and test pieces for footwear components and footwear, to carry out the test methods needed to determine the suitable properties for the end use.
These are the general conditions unless otherwise stated in the corresponding test method.
This Standard describes a test method for the determining of the resistance to separation of the upper from the outsole or to separate adjacent layers of the outsole or to cause tear failure of the upper or the sole is measures. It also defines conditions of aging that can be used for production control. It applies to all types of footwear (cementing, vulcanization, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembles (closed shoe).
This document describes a test method for determining the resistance to separation of the upper from the outsole, for separating adjacent layers of the outsole or for causing tear failure of the upper or the sole. It also defines conditions of ageing that can be used for production control.
This document is applicable to all types of footwear (cementing, vulcanisation, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembled (closed shoe).
NOTE 1 In all cases the objective is to test the bond strength nearest to the edge of the assembly.
NOTE 2 The test need not be carried out when the bond has been made by grindery (using, for example, nails or screws) or stitching.
This document specifies a method for the determination of the abrasion resistance for outsoles,
This document specifies three methods for determining the shape retention properties and compression strength of a doomed test specimen.
1.1 The requirements of this standard cover holders and connectors for electric lamps, including incandescent, fluorescent, and other electric-discharge-type lamps, rated as indicated in Clause 6, to be used in accordance with the Canadian Electrical Code (CEC), Part I, C22.1, and the National Electrical Code (NEC), ANSI/NFPA 70. 1.2 These requirements cover screw lampholders, including those intended to be mounted directly on an outlet-box, lampholders for special uses, lampholders for electric signs, and adapters that convert one lampholder size to another.
These requirements cover interlocked steel or aluminum armored cables that contain 2, 3, or 4, 14 – 1 AWG insulated circuit conductors with or without grounding conductors and are for use as Type AC Armored Cable in accordance with Article 320 and other applicable parts of the National Electrical Code (NEC), ANSI/NFPA 70. 1.2 These requirements cover cables for use at potentials of 600 V or less and at temperatures that are not higher than 75°C (167°F) for Type ACTH, or 90°C (194°F) for Types ACHH and ACTHH, depending upon the temperature rating of the insulated conductors used. Cables with aluminum armor are suitable only for use with connectors other than the direct-bearing set-screw type and only in alternating-current circuits.