Standards

This European Standard specifies a test method for assessing the tear strength of upper, linings and insocks or complete upper assembly, irrespective of t material, in order to assess the suitability for the end use.

This European Standard specifies a method for determining the flex resistance of outsoles. This method is intended to assess the effect of sole materials and surface patterns on cut growth. This method is applied to outsoles that, in accordance with the test mentioned in Clasuse6, have a maximum longitudinal rigidity of 30 N.

This European Standard specifies the sampling location, preparation and duration of conditioning of samples and test pieces for footwear components and footwear, to carry out the test methods needed to determine the suitable properties for the end use.

These are the general conditions unless otherwise stated in the corresponding test method.

This Standard describes a test method for the determining of the resistance to separation of the upper from the outsole or to separate adjacent layers of the outsole or to cause tear failure of the upper or the sole is measures. It also defines conditions of aging that can be used for production control. It applies to all types of footwear (cementing, vulcanization, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembles (closed shoe).

This document describes a test method for determining the resistance to separation of the upper from the outsole, for separating adjacent layers of the outsole or for causing tear failure of the upper or the sole. It also defines conditions of ageing that can be used for production control.

This document is applicable to all types of footwear (cementing, vulcanisation, injection moulding, etc.) where the evaluation of sole adhesion on the upper is needed and where the upper is continuously assembled (closed shoe).

NOTE 1 In all cases the objective is to test the bond strength nearest to the edge of the assembly.

NOTE 2 The test need not be carried out when the bond has been made by grindery (using, for example, nails or screws) or stitching.

This European Standard specifies a method for the determination of abrasion resistance for outsole, irrespective of the material.

This document specifies a method for the determination of the abrasion resistance for outsoles,

This document specifies three methods for determining the shape retention properties and compression strength of a doomed test specimen.

This standard gives requirements for the design, location, construction, and maintenance of septic tanks. It includes methods of treatment and disposal of septic tank effluent from domestic sewage. This standard is applicable to individual housing units and institutions where the number of users does not exceed twenty (20) persons. For buildings with more than twenty (20) users an alternative treatment method should be considered with the approval from the relevant authorities.

 This Regional Standard specifies requirements for hydraulic cements used primarily in the construction industry. It includes requirements for compressive strength, physical properties, chemical properties, packaging, labelling and the means of determining conformance to these requirements. It does not apply to Portland and blended cement. This standard does not apply to ASTM C150M Type IV cement.