Standards

This standard outlines a code of safety for chemical laboratories.

This specification covers poly(vinyl chloride) (PVC) pipe made in Schedule 40, 80, and 120 sizes and pressure-rated for water (see Appendix X1). Included are criteria for classifying PVC plastic pipe materials and PVC plastic pipe, a system of nomenclature for PVC plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, flattening, and extrusion quality. Methods of marking are also given.

This specification covers poly(vinyl chloride) (PVC) pipe made in standard thermoplastic pipe dimension ratios and pressure rated for water (see appendix). Included are criteria for classifying PVC plastic pipe materials and PVC plastic pipe, a system of nomenclature for PVC plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, flattening, and extrusion quality. Methods of marking are also given.

This standard specifies requirements for the operation of testing and/or calibration laboratories. It is applicable to all laboratories regardless of the number of personnel or the extent of the scope of testing activities.

This standard specifies attachment fused and unfused plugs (caps), shuttered receptacles (sockets) for flush surface mounting. These plugs and sockets are suitable for alternating current circuits only of voltages not exceeding 250 volts and currents not exceeding 15 amperes.  The plugs and receptacles covered by this standard are intended for use in making readily detachable electrical connections in non-hazardous locations between supply circuits and portable lamps, appliances and similar equipment.

The standards and requirements in this document are the pre-requisite conditions for the issuance of a Technical Acceptance certificate (TAC) for television broadcasting transmitters.

This standards covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.

This standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80 C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code.. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.

BESP 100, Issue 1, November 1, 1996. This procedure describes the process for obtaining a Technical Acceptance Certificate (TAC) for Broadcasting Equipment.

This standard specifies the general requirements for a laboratory safety management system, which will enable a laboratory to formulate a policy and objectives, taking into account legislative requirements and information about significant risks, which the laboratory can control and over which it can be expected to have an influence, to protect its employees and others, whose health and safety may be affected by the activities of the laboratory. In addition this standard specifies specific requirements for medical laboratories. This standard is applicable to any laboratory that wishes to: (a) implement, maintain and improve an Occupational Safety and Health Management System; (b) assure itself of its conformance with its stated safety policy; and (c) make s self-determination and self –declaration of conformance with this standard.