Standards

This standard specifies the general labelling requirements for Electrical Equipment, Fittings and household electrical appliances and their detachable heating element(s) if any, offered for sale in Guyana. This Guyana Standard shall be applied for all Electrical Equipment, Fittings and household electrical appliance, should there be a standard for a particular product it shall be applied in conjunction with the labelling requirements of this standard.

These requirements cover household motor-operated food preparing machines and kitchen accessories such as knife sharpeners and can openers that are intended to be operated for short-periods of time.

This Standard applies to self-contained household refrigerators and freezers designed to be installed and used in residential occupancies in accordance with the Canadian Electrical Code, Part 1, CSA Standard C22.1, and the National Electrical Code, ANSI/NFPA 70.

This standard specifies attachment fused and unfused plugs (caps), shuttered receptacles (sockets) for flush surface mounting. These plugs and sockets are suitable for alternating current circuits only of voltages not exceeding 250 volts and currents not exceeding 15 amperes.  The plugs and receptacles covered by this standard are intended for use in making readily detachable electrical connections in non-hazardous locations between supply circuits and portable lamps, appliances and similar equipment.

The requirements cover television equipment intended for household and commercial use on supply circuits in accordance with the National Electrical Code, NFPA 70. 

The standards and requirements in this document are the pre-requisite conditions for the issuance of a Technical Acceptance certificate (TAC) for television broadcasting transmitters.

This standards covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.

This standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80 C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code.. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.

BESP 100, Issue 1, November 1, 1996. This procedure describes the process for obtaining a Technical Acceptance Certificate (TAC) for Broadcasting Equipment.