Standards
This Standard specifies requirements for rolls of one ply and two toilet tissue. The standard also prescribes labelling requirements, sampling and method of test. It does not cover facial tissue or paper towels.
Within the general scope defined in Section I, ANSI/ASME B30.17 applies to overhead and gantry cranse with a top running bridge, of single-girder construction, utilizing one or more underhung hoists (see ANSI B30.16) operating on the bottom flange of the bridge girder. This Standard includes both power-driven and hand-operated equipment.
This standard specifies requirements for bread including buns and rolls and methods of test for these requirements.
This standard specifies requirements for bread and rolls and methods of test for these requirements.
This standard specifies construction, operation, safety requirements, labelling and tests for domestic gas stoves with metallic bodies intended for use with liquefied petroleum gases at 2.452 to 3.432 kN/m2 (or equivalent) gas inlet pressure.
This standard specifies physical dimensions, performance and marking requirements for pneumatic tyres for highway commercial vehicles. Test methods for determining conformity to the performance requirements are also included.
This standard specifies physical dimensions, performance and marking requirements for new, used and retreaded pneumatic tyres for highway commercial vehicles.
This standard also includes test methods for determining conformity to the performance requirements stated.
This standard specifies requirements for hollow blocks made from fired clay. The standard covers the general quality, dimensions and strength of the blocks.
This standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80 C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code.. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.
This Japanese Standard specifies the seat belt assembles for automobiles, hereinafter referred to as the “Seat belt” to accommodate one adult and to be fitted principally to forward facing seat for the purpose of protecting the wearer from injury in the event of a traffic accident.