Standards

This document specifies designations for filler materials for brazing on the basis of their chemical composition. The designation includes their solidus/liquidus temperatures. This document applies to the metallic part of filler materials used in brazing products, for example foils, wires, rods, pastes, flux-coated rods or wires and flux-cored rods or wires.

 This standard specifies a test method for determining the acceptance limits of surface discontinuities detected by magnetic particle inspection, when such an inspection procedure has been contractually agreed upon at the request of the purchaser.  It applies to all magnetic steel castings; whatever casting process is used.  A steel shall be considered to be magnetic if the magnetic induction is greater than 1 T for a magnetic field

strength equal to 2, 4 KA/m.

This document specifies a method for the magnetic particle testing of ferro-magnetic steel and iron castings. It also gives acceptance criteria through severity levels defined by the nature, the area and the dimensions of the discontinuities present. This document is applicable to all ferro-magnetic castings, independent of the moulding method. A steel and iron casting is considered to be ferro-magnetic if the magnetic induction is greater than 1 T

(Tesla) for a magnetic field strength of 2,4 kA/m. This document only applies to those areas of the castings specified for testing, as well as the percentage

of castings to be tested

This standard specifies a test method for determining the acceptance limits of surface discontinuities detected by liquid penetrant inspection, when such an inspection procedure has been contractually agreed upon at the request of the purchaser. It applies to all steel castings; whatever casting process is used.

This document specifies a method for the liquid penetrant testing of steel and iron castings.

 For the interpretation of radiographs and the assignment of radiographic quality levels to a casting, it is necessary to use a standard set of reference radiographs. The reference radiographs available from ASTM (see clause 2) are the only internationally used and recognized documents that may be used for this purpose.

This document specifies the general requirements for the radiography of steel and iron castings by means of X-rays or gamma-rays.

This standard specifies the testing conditions and the acceptance standard for ultrasonic acceptance tests for the components and types of test covered in table 1, columns 1 to 6.  Unless otherwise agreed, this standard shall be applied when the product standards require mandatory ultrasonic tests or when the ordered optional tests are made mandatory (See ISO 1005-1, ISO 1005-3 and ISO 1005-6) ISO 1005-6, specifies ultrasonic acceptance tests are mandatory for all wheels of testing category B, but optional for all wheels of testing category A. According to ISO 1005-1 and ISO 1005-3, ultrasonic acceptance tests on tyres and axles are optional in every case.

This standard specifies general rules for appropriate implementation of radiographic inspection and stresses the technical specifications to be defined for agreement on discontinuity acceptance criteria by this technique. It applies to aluminum castings.

 This standard specifies a method for liquid penetrant inspection of discontinuities rising to the surface of aluminium alloy and magnesium alloy products and castings. It also defines severity levels as a function of the nature and number of discontinuities present. This standard applies to all aluminium alloy and magnesium alloy castings, whatever their grade and the casting procedure used to produce them.