Standards

This standard specifies requirements and dimensions for PVC insulated cables for operation at nominal voltages up to and including 1900 V to armour or earth and 3300 V between conductors.

This standard describes the properties of mercury the nature of hazards associated with it and essential information on its storage, handling packing , labelling disposal of waste and personal preventive measures.

This standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80 C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code.. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.

BESP 100, Issue 1, November 1, 1996. This procedure describes the process for obtaining a Technical Acceptance Certificate (TAC) for Broadcasting Equipment.

This standard sets out guidelines parameters which will be used to monitor the effluent quality for different types of industries operating in Guyana.  This standard does not apply to industrial operations of mining, forestry operations and agricultural infiltration, seepage and run-off.  This standard is expected to operate under the Environmental Protection Agency (EPA) regulations on Water Quality Management

These requirements cover ballasts of the resistance, reactance, and electronic (solid state) types for use with fluorescent lamps involving a potential of 2500 volts or less in accordance with the National Electrical Code, NEPA 70. A fluorescent lamp ballast may be determined by investigation to be acceptable for use, in a fixture or other device, with electric-discharge lamps of other than the fluorescent type. A product that contains features, characteristics, components, materials, or systems new or different from those in use when the standard was developed, and that involves a risk of fire, electric shocks, or injury to persons shall be evaluated using the appropriate additional component and end-product requirements as determined necessary to maintain the level of safety for the user of the product as originally; anticipated by the intent of this standard.

These requirements cover portable, stationary, and fixed uninterruptible power supplies (UPS) rated 600 volts or less ac or dc that are intended for installation in accordance with the National Electrical Code, NFPA 70.  During intended operation, the UPS allows the utility to deliver ac and dc power to the connected load through either the power conversion portion of the UPS or a bypass source. The power conversion portion of the UPS consists of a rectifier and an inverter.  During periods of power fluctuations, or power outage, or both, the connected load receives ac and dc power from the battery supply and power conversion portion of the UPS.

This standard prescribes methods of sampling and testing for Biochemical Oxygen Demand five days (BOD₅) in water and wastewater.  It shall be read in conjunction with the latest version of GYS 207 “Interim guidelines for industrial effluent discharge into the environment.”

 This standard prescribes methods of sampling and testing for solids in water and wastewater.

This standard prescribes methods of sampling and testing for, dissolved oxygen in water and wastewater.  It shall be read in conjunction with latest edition of GYS 207, “Interim guidelines for industrial effluent discharge into the environment.