Standards
This standard establishes the basic principles for carrying out vibration measurement and processing data, with regard to evaluating vibration effects on buildings. The evaluations of the effects of building vibration are primarily directed at structural response, and include appropriate analytical methods where the frequency, duration and amplitude can be defined. It only deals with the measurement of structural vibration and excludes the measurement of airborne sound pressure and other pressure fluctuations.
This standard defines working positions and makes it possible to locate welds in space with reference to the horizontal reference plane (usually parallel to the workshop floor) by means of angles of slope and rotation which are independent from surrounding construction.
This standard gives recommendations on the serviceability of buildings against vibrations. It covers three recipients of vibrations: a) human occupancy in buildings and on pedestrian bridges; b) the contents of the building; c) the structure of the building. It applies to buildings, pedestrian bridges and walkways found within buildings or connecting them and does not include bridges that carry vehicular traffic, nor the design of foundations or supporting structures of machinery.
This standard applies to electric cooking and heating appliances and to electric ,motor-operated or magnetically-driven appliances for household and similar purposes, including office machines.
This standard specifies
attachment fused and unfused plugs (caps), shuttered receptacles (sockets) for
flush surface mounting. These plugs and sockets are suitable for alternating
current circuits only of voltages not exceeding 250 volts and currents not
exceeding 15 amperes. The plugs and
receptacles covered by this standard are intended for use in making readily detachable
electrical connections in non-hazardous locations between supply circuits and
portable lamps, appliances and similar equipment.
Within the general scope defined in Section I, ANSI/ASME B30.17 applies to overhead and gantry cranse with a top running bridge, of single-girder construction, utilizing one or more underhung hoists (see ANSI B30.16) operating on the bottom flange of the bridge girder. This Standard includes both power-driven and hand-operated equipment.
This standard specifies requirements for two grades of unleaded gasoline in Guyana for use in motor vehicles with spark-ignition internal combustion engines. It also specifies a method for determining adulteration of premium gasoline with regular gasoline.
The standards and requirements in this document are the pre-requisite conditions for the issuance of a Technical Acceptance certificate (TAC) for television broadcasting transmitters.
This standards covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.