Standards

This standard specifies requirements for ultrasonic thickness testing of seamless and welded tubes for pressure purposes, with the exception of submerged arc-welded (SAW) tubes, for verification of hydraulic leak-tightness.

This standard specifies requirements for full peripheral ultrasonic thickness testing of seamless and hot-stretch-reduced welded steel tubes.

This standard describes the qualification and certification of personnel engaged in non-destructive testing (NDT) of seamless and welded steel tubes, including flat products used in the manufacture of welded tubes, for pressure purposes. It specifies the training, qualification and certification requirements for three levels of NDT personnel competence to execute specific tasks in the NDT of seamless and welded steel tubes, including the weld seam, and flat products used in the manufacture of welded tubes.

This standard specifies requirements for full peripheral ultrasonic testing of the ends of seamless and welded tubes for the detection of laminar imperfections. It is intended to detect, over a zone at the ends of plain end and bevelled end tubes, laminar imperfections which may interfere with subsequent fabrication operations (e.g.) welding, ultrasonic inspection of welds, etc). This standard is applicable to the inspection of tubes with an outside diameter greater than 30 mm. No lower limit of thickness is specified, but see note 1.

This second edition cancels and replaces the first edition (ISO 5182:1978). Specifies the characteristics of the materials which are used for carrying current and transmitting force to the work. Gives normative references. Defines the term softening temperature. Classifies copper and copper alloys and sintered materials. Specifies test methods, designation, typical applications (annex A), hardness conversions (annex B). Annexes C and D contain properties and bibliography, respectively.

This standard lays down requirements for tungsten electrodes for inert gas shielded arc welding, and for plasma cutting and welding.  

 This standard lays down the general specifications, requirements and tests of safety devices for fuel gases and oxygen or compressed air used downstream of cylinder or pipeline outlet regulators and of pipeline outlet valves, and upstream of blowpipes for welding, cutting and allied processes. It does not specify location and combination of these devices in the gas system.  

This document specifies the general requirements and tests for safety devices for fuel gases and oxygen or compressed air which do not incorporate a flame (flashback) arrestor used downstream of manifold, cylinder and/or pipeline outlet regulators, and upstream of blowpipes for welding, cutting and allied processes. This document does not specify the location of these devices in the gas system. This document is not applicable to safety devices which incorporate a flame arrestor, covered by ISO 5175-1.

  This standard specifies requirements for taper plug and ring gauges used for the checking of type A, B and C tapers according to ISO 1089. 

 This standard specifies the dimensions and tolerances of resistance spot welding electrode adaptors where the fixing element for the cap is a female taper (male electrode cap, see ISO 5830) and for which the electrode taper fits conform to ISO 1089.