Standards

This test method covers the determination of the adequacy of fusion of extruded rigid poly (vinyl chloride) (PVC) pipe and molded fittings as indicated by reaction to immersion in anhydrous acetone.

This test method covers the determination of diameter, wall thickness, and length dimensions of thermoplastic pipe. Included are procedures for measurement of the inside diameter of pipe intended to be joined by internal fittings, measurement of the average outside diameter for roundtable pipe where out-of-roundness is not of primary concern, out-of-roundness measurement and measurement of the average outside diameter of non-roundtable pipe, and for determining length and straightness.

This test method covers the determination of the impact resistance of thermoplastic pipe and fittings under specified conditions of impact by means of a tup (falling weight) . Three interchangeable striking noses are used on the tup, differing in geometrical configuration. Two specimen holders are described.

The purpose of these abbreviations is to provide uniform contractions of terms relating to plastics. Abbreviated terminology has evolved through widespread common usage. This compilation of abbreviated nomenclature has been prepared to avoid the occurrence of ore than one abbreviation for a given plastics term, and double meanings for particular abbreviations.

This specification covers poly (vinyl chloride) (PVC) pipe made in standard thermoplastic pipe dimension ratios and pressure rated for water (see Appendix). Included are criteria for classifying PVC plastic pipe materials and PVC plastic pipe, a system of nomenclature for PVC plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, flattening, and extrusion quality. Methods of marking are also given.

The products covered by this specification are intended for use with the distribution of pressurized liquids only, which are chemically compatible with the piping materials. Due to inherent hazards associated with testing components and systems with compressed air or other compressed gases, some manufacturers do not allow pneumatic testing of their products. Consult with specific product/component manufacturers for their specific testing procedures prior to pneumatic testing.

This specification covers poly(vinyl chloride) (PVC) pipe made in standard thermoplastic pipe dimension ratios and pressure rated for water (see appendix). Included are criteria for classifying PVC plastic pipe materials and PVC plastic pipe, a system of nomenclature for PVC plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, flattening, and extrusion quality. Methods of marking are also given.

This standard outlines the specification for cosmetics and personal care items for newborns (birth to 1 month), infants (1 month to 1 year), and young children (1 year through 6 years). The use of items with therapeutic claims is not covered by this standard.

This standard specifies the requirements for cosmetics and toiletry products as listed in Clause 3 and intended for use in the care of newborns, infants and young children. Products for which therapeutic claims are made are not covered by this standard.

  This standard specifies requirements for dusting powder prepared from a blend of materials to produce the characteristics set out in clause 2. It does not apply to aerosols.

This standard specifies the requirements for baby powder prepared from a blend of materials to produce the characteristics set out in Clause 4. It applies to baby powder used for newborns (birth to 1 month), infants (1 month to 1 year), and young children (1 year through 6 years). It does not apply to aerosols.