Standards
This standard outlines a code of safety for chemical laboratories.
This standard specifies requirements for the labelling of household chemicals sold in Guyana, whether locally made or imported, and gives a series of warning labels corresponding to the designated classes of dangerous goods as detailed in Appendix A. This standard shall be read in conjunction with GYS 9-1 :1994, “Specification for labelling of commodities - Part 1: General principles”.
This standard defines working positions and makes it possible to locate welds in space with reference to the horizontal reference plane (usually parallel to the workshop floor) by means of angles of slope and rotation which are independent from surrounding construction.
This standard gives recommendations on the serviceability of buildings against vibrations. It covers three recipients of vibrations: a) human occupancy in buildings and on pedestrian bridges; b) the contents of the building; c) the structure of the building. It applies to buildings, pedestrian bridges and walkways found within buildings or connecting them and does not include bridges that carry vehicular traffic, nor the design of foundations or supporting structures of machinery.
This standard specifies
attachment fused and unfused plugs (caps), shuttered receptacles (sockets) for
flush surface mounting. These plugs and sockets are suitable for alternating
current circuits only of voltages not exceeding 250 volts and currents not
exceeding 15 amperes. The plugs and
receptacles covered by this standard are intended for use in making readily detachable
electrical connections in non-hazardous locations between supply circuits and
portable lamps, appliances and similar equipment.
The standards and requirements in this document are the pre-requisite conditions for the issuance of a Technical Acceptance certificate (TAC) for television broadcasting transmitters.
This standards covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.
This standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80 C (176 F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code.. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape . Thermoplastic tape is acceptable without the additional mechanical protection.
BESP 100, Issue 1, November 1, 1996. This procedure describes the process for obtaining a Technical Acceptance Certificate (TAC) for Broadcasting Equipment.
This standard specifies performance requirements for hollow load-bearing concrete masonry units made from Portland cement, water and mineral aggregates with or without the inclusion of other materials. It covers three weight classifications of the concrete masonry units: (a) normal weight; (b) medium weight; and (c) lightweight.