Standards

This standard specifies basic methods for testing the physical properties of paints and surface coatings.

The standard prescribes a maximum limit on the lead content in paints and varnishes supplied in fluid form. It applies to paints and varnishes that are used in households, on domestic furniture and appliances, in buildings and places open to the public shops, offices, factories, or for commercial purposes. This standard does not apply to paints supplied in the form of dried powder, or intended for industrial use.

This standard applies to emulsion paint for interior and exterior use on masonry surfaces including concrete, brick, stucco, concrete block and on primed wood. It is not suitable for metal derived products.

This standard applies to low sheen and semi-gloss emulsion paint for use on types of interior and exterior wall surfaces and ceilings. It is suitable for application over surfaces including wallboard, gypsum-board, cement, dry plaster, brick, concrete block wall or block walls rendered with cement-mortar, gypsum plaster or any other such material applied for providing a protective coating.

This standard prescribes requirements for ready mixed alkyd paint for interior and exterior applications. The material is used for protection and decoration of wood and metal and other surfaces suitably primed.  

This document specifies the general requirements for the competence, impartiality and consistent operation of laboratories. It is applicable to all organizations performing laboratory activities, regardless of the number of personnel.

Laboratory customers, regulatory authorities, organizations and schemes using peer-assessment, accreditation bodies, and others use this document in confirming or recognizing the competence of laboratories.

This standard specifies the requirements and the methods of sampling and test for lacquer. 

This standard specifies methods of sampling and test for thinners and solvents for paints.  It covers the methods for determination of colour, relative density, distillation range, residue on evaporation, tests for corrosive sulphur, freedom from chlorinated hydrocarbon solvents and benzene, kauri butanol value, aniline point and mixed aniline point, acid wash test, test for hydrogen sulphide and mercaptans, freedom from lead, flash point and keeping quality.

 This standard specifies the general requirements for a laboratory safety management system, which will enable a laboratory to formulate a policy and objectives. It takes into account legislative requirements and information about significant risks, that the laboratory can control and over which  it can be expected to have an influence, to protect its employees and others, whose health and safety may be affected by the activities of the laboratory. 

This standard specifies the general requirements for a laboratory safety management system, which will enable a laboratory to formulate a policy and objectives, taking into account legislative requirements and information about significant risks, which the laboratory can control and over which it can be expected to have an influence, to protect its employees and others, whose health and safety may be affected by the activities of the laboratory. In addition this standard specifies specific requirements for medical laboratories. This standard is applicable to any laboratory that wishes to: (a) implement, maintain and improve an Occupational Safety and Health Management System; (b) assure itself of its conformance with its stated safety policy; and (c) make s self-determination and self –declaration of conformance with this standard.