Standards
Gas welding equipment — Safety devices- Part 1: Devices not incorporating a flame (flashback) arrestor
This document specifies the general requirements and tests for safety devices for fuel gases and oxygen or compressed air which do not incorporate a flame (flashback) arrestor used downstream of manifold, cylinder and/or pipeline outlet regulators, and upstream of blowpipes for welding, cutting and allied processes. This document does not specify the location of these devices in the gas system. This document is not applicable to safety devices which incorporate a flame arrestor, covered by ISO 5175-1.
GYS 142-2
-
2025
GYD 5,500
20 pages
Specification for Rotationally moulded polyethylene water storage tanks
This standard covers flat-bottomed water storage tanks of circular cross-section manufactured from unreinforced polyethylene by the process of rotational moulding. Included are requirements for physical characteristics, dimensions, materials performance, testing marking and labelling.
This standard covers flat-bottomed water storage tanks of circular cross-section manufactured from unreinforced polyethylene by the process of rotational moulding. Included are requirements for physical characteristics, dimensions, materials performance, testing marking and labelling.
These specifications apply to tanks intended for:
(a) The storage of potable water at normal atmospheric pressure;
(b) Installation and use at environmental or service temperatures such that the material of tank remains between 15 °C and 80°C; and
(c) Vertical, above- ground installation on fixed, flat, fully- supporting bases.
GYS 588
-
2023
GYD 6,100
27 pages