This standard outlines a code of safety for chemical laboratories.

1                   Scope

1.1               This standard outlines a code of safety for chemical laboratories.

1.2              The standard outlines:

(a)               general rules of conduct concerning safety;

(b)               details for fire emergency and rescue procedures;

(c)               general laboratory techniques.

1.3              This standard does not cover hazards relating to radioactive substances.

This standard specifies basic methods for testing the physical properties of paints and surface coatings.

The standard prescribes a maximum limit on the lead content in paints and varnishes supplied in fluid form. It applies to paints and varnishes that are used in households, on domestic furniture and appliances, in buildings and places open to the public shops, offices, factories, or for commercial purposes. This standard does not apply to paints supplied in the form of dried powder, or intended for industrial use.

This standard specifies requirements for the operation of testing and/or calibration laboratories. It is applicable to all laboratories regardless of the number of personnel or the extent of the scope of testing activities.

This standard applies to emulsion paint for interior and exterior use on masonry surfaces including concrete, brick, stucco, concrete block and on primed wood. It is not suitable for metal derived products.

This standard applies to low sheen and semi-gloss emulsion paint for use on types of interior and exterior wall surfaces and ceilings. It is suitable for application over surfaces including wallboard, gypsum-board, cement, dry plaster, brick, concrete block wall or block walls rendered with cement-mortar, gypsum plaster or any other such material applied for providing a protective coating.

This standard prescribes requirements for ready mixed alkyd paint for interior and exterior applications. The material is used for protection and decoration of wood and metal and other surfaces suitably primed.  

This standard applies to electric cooking and heating appliances and to electric ,motor-operated or magnetically-driven appliances for household and similar purposes, including office machines.

This standard specifies attachment fused and unfused plugs (caps), shuttered receptacles (sockets) for flush surface mounting. These plugs and sockets are suitable for alternating current circuits only of voltages not exceeding 250 volts and currents not exceeding 15 amperes.  The plugs and receptacles covered by this standard are intended for use in making readily detachable electrical connections in non-hazardous locations between supply circuits and portable lamps, appliances and similar equipment.