Standards

This Code of Practice specifies the requirements for concrete and block masonry used in structures or buildings.

This Code of Practice establishes the recommendations for the hygienic preparation of packaged natural coconut water  inclusive of harvesting, processing, packaging, storing, transporting and distributing.

This document applies to single storey houses up to 7.62 m x 12.19 m (25 ft x 40 ft) plan, with hollow block masonry or timber framed walls, and timber framed or concrete roofs.  It provides the user with the technical information to supervise the construction of a safe and durable house, and to facilitate checks on whether a safe and durable house is being built.

This document does not include construction details for utilities (including plumbing, electrical, communications, security, and natural gas.  It also does not include construction details for solid brick masonry.

This standard describes exhaust emission requirements for all new domestic and commercial vehicles which have been registered in Guyana for the first time after December 31, 1997. This standard also describes exhaust emission requirements, measurement methods and measurement equipment for all vehicles, which are imported into Guyana after December 31, 1997. All imported vehicles would be required to conform to exhaust emission limits specified in the standard. Accordingly, the exhaust emission limits must be fully documented and certified by the suppliers/manufacturers, from the country of origin.

 This standard establishes the basic principles for carrying out vibration measurement and processing data, with regard to evaluating vibration effects on buildings. The evaluations of the effects of building vibration are primarily directed at structural response, and include appropriate analytical methods where the frequency, duration and amplitude can be defined. It only deals with the measurement of structural vibration and excludes the measurement of   airborne sound pressure and other pressure fluctuations. 

This standard provides general guidance on methods of carrying out penetrant inspection on materials and components both during manufacture and in service. It does not deal with acceptance or rejection. Penetrant inspection is used to locate discontinuities, such as laps, folds, cracks, porosity and fissures, which are open to the surface of a material or component. Penetrant techniques can be used on materials irrespective of their physical properties, provided that the surface is normally non-absorbent and compatible with the penetrant process. 

This standard provides general guidance on

. This standard specifies the minimum requirements for industrial illuminators used for viewing radiographs.