Standards
1.1 This standard specifies:
(a) requirements for the manufacturing, alloying and testing of gold articles of 23, 22, 20, 18, 15, 14, 12, 10 and 9 kt gold;
(b) requirements for findings and solders to be used in the manufacture of gold articles;
(c) methods for assaying gold, alloyed gold, solder, findings and gold articles;
(d) non-destructive testing of gold articles by X-ray fluorescence spectroscopy (XRF); and
(e) requirements for making and labelling of imported gold articles.
NOTE 1 It does not specify requirements for design of gold articles and does not apply to gold articles intended for industrial purpose such as dentistry, electronics, official coins, gold bars and other such uses.
This standard specifies:
a a) requirements for the manufacturing, alloying and testing of gold articles of 23, 22, 20, 18, 15, 14,12, 10 and 9 kt gold;
b b) requirements for findings and solders to be used in the manufacture of gold articles;
c c) methods for assaying gold, alloyed gold, solder, findings and gold articles; and
d d) requirements for marking and labelling of imported gold articles.
NNOTE It does not specify requirements for design of gold articles and does not apply to gold articles intended for industrial purposes such as dentistry, electronics, official coins, gold bars and other such uses.
This standard applies to the storage and handling of portable containers used for storage of Liquefied Petroleum Gases (LPG) and to the transportation of these containers.
This standard does not cover the storage, handling and transport of ammonia cylinders.
The main text of this national standard contains a list of these parameters, their units and references to measurement standards. Informative annexes give examples of typical values for these parameters, with the main emphasis on health and safety. In defining the parameters governing composition, physical properties and trace constituents, consideration has also been given to existing natural gases to ensure their continuing viability.
The question of interchangeability is dealt with in Annex A (see Clause A.2).
Fuel meeting the requirements of this part of ISO 15403 should:
(a) provide for the safe operation of the vehicle and associated equipment needed for its fuelling and maintenance;
(b) protect the fuel system from the detrimental effects of corrosion, poisoning, and liquid or solid deposition;
(c) provide satisfactory vehicle performance under any and all conditions of climate and driving demands.
Some aspects of this part of ISO 15403 may also be applicable for the use of natural gas in stationary combustion engines.
1.1 This specification (see Note 1) covers grades of fuel oil intended for use in various types of fuel oil-burning equipment under various climatic and operating conditions. These grades are described as follows:
1.1.1 Grades No. 1 S5000, No. 1 S500, No. 1 S15, No. 2 S5000, No. 2 S500, and No. 2 S15 are middle distillate fuels for use in domestic and small industrial burners. Grades No. 1 S5000, No. 1 S500, and No. 1 S15 are particularly adapted to vaporizing type burners or where storage conditions require low pour point fuel.
1.1.2 Grades B6–B20 S5000, B6–B20 S500, and B6–B20 S15 are middle distillate fuel/biodiesel blends for use in domestic and small industrial burners.
1.1.3 Grades No. 4 (Light) and No. 4 are heavy distillate fuels or middle distillate/residual fuel blends used in commercial/industrial burners equipped for this viscosity range.
1.1.4 Grades No. 5 (Light), No. 5 (Heavy), and No. 6 are residual fuels of increasing viscosity and boiling range, used in industrial burners. Preheating is usually required for handling and proper atomization.