Standards

This Code of Practice gives recommendations for storage of tyres, inner tubes and flaps.

This publication was last reviewed and confirmed in 2025. Therefore this version remains current.

This Code of Practice specifies the requirements for concrete and block masonry used in structures or buildings.

This standard sets out general requirements for the contents of advertising, shown or consumed in Caricom Member States, in any medium, whether foreign or locally generated. It also prescribes additional requirements for the following types of advertisements: advertisements of specific classes of goods or services, advertising directed to specific categories of consumers, and advertisements in certain media. This standard also prescribes requirements for the manner of presentation of advertisements.

This standard specifies guidelines which would prevent the arousal of high expectations which would lead to disappointment, or cause conflict with parental decisions.

This Guyana Standard is a glossary which defines terms related to passenger car and commercial vehicle tyres. The standard is divided into six sections dealing respectively with general definitions, definitions related to structure, main components, tyre dimensions, service, injury and repair.

This document contains the standards governing TV broadcasting systems. The standards ensure satisfactory monochrome and colour television broadcasting services based on the 525-line NTSC colour system. The system is known as NTSC/M  

This standard specifies requirements for hollow blocks made from fired clay.  The standard covers the general quality, dimensions and strength of the blocks.

This standard specifies requirements, including dimensions, materials, finish and selection for sampling for wire nails and cut nails. The following types of wire nails are covered by this standard: (a) Round plain head nails; (b) Round lost head nails; (c) Clout or slate nails; (d) Extra large head clout or felt nails; (e) Convex head roofing nails (chisel or diamond points); (f) Pipe nails (chisel point); (g) Panel pins; (h) Hardboard panel pins (round shank); (i) Hardboard panel pins (square shank); (j) Lath nails; (k) Plasterboard nails (jagged shank); (l) Oval brad head nails; (m) Oval lost head nails; (n) Tile pegs; (o) Tram nails with flat or raised head with chisel point; (p) Spring head twisted shank nails; (q) Square twisted shank flat head nails; (r) Washer head slab nails; (s) Dowels; (t) Annular ringed shank flat head nails; (u) Helical threaded shank flat head nails; and (v) Duplex head nails. The following types of cut nails are covered by this standard: (a) Cut clasp nails; and (b) Cut floor brads. The types of nail covered are illustrated in Tables 1 to 25 and in the corresponding diagrams, Figures 1 to 25.