This standard specifies the general labelling requirements for electrical equipment, fittings and electrical appliances and their detachable heating element(s) if any, offered for sale in Guyana.

This Guyana Standard shall be applied to all electrical equipment, fittings and electrical appliances and should therefore be a standard for a particular product. It shall be applied in conjunction with the labelling requirements of this standard.

This standard specifies the general labelling requirements for Electrical Equipment, Fittings and household electrical appliances and their detachable heating element(s) if any, offered for sale in Guyana. This Guyana Standard shall be applied for all Electrical Equipment, Fittings and household electrical appliance, should there be a standard for a particular product it shall be applied in conjunction with the labelling requirements of this standard.

1.1         This standard specifies:

(a)          requirements for the manufacturing, alloying and testing of gold articles of 23, 22, 20, 18, 15, 14, 12, 10 and 9 kt gold;

(b)         requirements for findings and solders to be used in the manufacture of gold articles;

(c)          methods for assaying gold, alloyed gold, solder, findings and gold articles;

(d)         non-destructive testing of gold articles by X-ray fluorescence spectroscopy (XRF); and

(e)          requirements for making and labelling of imported gold articles.

NOTE 1 It does not specify requirements for design of gold articles and does not apply to gold articles intended for industrial purpose such as dentistry, electronics, official coins, gold bars and other such uses.

  This standard specifies:

a a)  requirements for the manufacturing, alloying and testing of gold articles of 23, 22, 20, 18, 15, 14,12, 10 and 9 kt gold;

b b) requirements for findings and solders to be used in the manufacture of gold articles;

c c) methods for assaying gold, alloyed gold, solder, findings and gold articles; and

d d) requirements for marking and labelling of imported gold articles.

 
NNOTE It does not specify requirements for design of gold articles and does not apply to gold articles intended for industrial purposes such as dentistry, electronics, official coins, gold bars and other such uses.

This standard specifies basic methods for testing the physical properties of paints and surface coatings.

The standard prescribes a maximum limit on the lead content in paints and varnishes supplied in fluid form. It applies to paints and varnishes that are used in households, on domestic furniture and appliances, in buildings and places open to the public shops, offices, factories, or for commercial purposes. This standard does not apply to paints supplied in the form of dried powder, or intended for industrial use.

This document specifies a method for the magnetic particle testing of ferro-magnetic steel and iron castings. It also gives acceptance criteria through severity levels defined by the nature, the area and the dimensions of the discontinuities present. This document is applicable to all ferro-magnetic castings, independent of the moulding method. A steel and iron casting is considered to be ferro-magnetic if the magnetic induction is greater than 1 T

(Tesla) for a magnetic field strength of 2,4 kA/m. This document only applies to those areas of the castings specified for testing, as well as the percentage

of castings to be tested

This document specifies a method for the liquid penetrant testing of steel and iron castings.

This standard applies to emulsion paint for interior and exterior use on masonry surfaces including concrete, brick, stucco, concrete block and on primed wood. It is not suitable for metal derived products.

This standard applies to low sheen and semi-gloss emulsion paint for use on types of interior and exterior wall surfaces and ceilings. It is suitable for application over surfaces including wallboard, gypsum-board, cement, dry plaster, brick, concrete block wall or block walls rendered with cement-mortar, gypsum plaster or any other such material applied for providing a protective coating.