Standards

This standard specifies basic methods for testing the physical properties of paints and surface coatings.

The standard prescribes a maximum limit on the lead content in paints and varnishes supplied in fluid form. It applies to paints and varnishes that are used in households, on domestic furniture and appliances, in buildings and places open to the public shops, offices, factories, or for commercial purposes. This standard does not apply to paints supplied in the form of dried powder, or intended for industrial use.

This document specifies the general requirements and tests for safety devices for fuel gases and oxygen or compressed air which do not incorporate a flame (flashback) arrestor used downstream of manifold, cylinder and/or pipeline outlet regulators, and upstream of blowpipes for welding, cutting and allied processes. This document does not specify the location of these devices in the gas system. This document is not applicable to safety devices which incorporate a flame arrestor, covered by ISO 5175-1.

This standard applies to emulsion paint for interior and exterior use on masonry surfaces including concrete, brick, stucco, concrete block and on primed wood. It is not suitable for metal derived products.

This standard applies to low sheen and semi-gloss emulsion paint for use on types of interior and exterior wall surfaces and ceilings. It is suitable for application over surfaces including wallboard, gypsum-board, cement, dry plaster, brick, concrete block wall or block walls rendered with cement-mortar, gypsum plaster or any other such material applied for providing a protective coating.

This standard prescribes requirements for ready mixed alkyd paint for interior and exterior applications. The material is used for protection and decoration of wood and metal and other surfaces suitably primed.  

This standard specifies the requirements and the methods of sampling and test for lacquer. 

This standard specifies methods of sampling and test for thinners and solvents for paints.  It covers the methods for determination of colour, relative density, distillation range, residue on evaporation, tests for corrosive sulphur, freedom from chlorinated hydrocarbon solvents and benzene, kauri butanol value, aniline point and mixed aniline point, acid wash test, test for hydrogen sulphide and mercaptans, freedom from lead, flash point and keeping quality.

This document specifies the requirements for the audit and certification of a food safety management system (FSMS) complying with the requirements given in ISO 22000 (or other specified FSMS requirements). It also provides the necessary information and confidence to customers about the way certification of their suppliers has been granted.

Certification of FSMS is a third-party conformity assessment activity (as described in ISO/IEC 17000:2020, 4.3), and bodies performing this activity are third-party conformity assessment bodies.

NOTE 1 In this document, the terms “product” and “service” are used separately (in contrast with the definition of “product” given in ISO/IEC 17000).

NOTE 2 This document can be used as a criteria document for the accreditation or peer assessment of certification bodies which seek to be recognized as being competent to certify that an

FSMS complies with ISO 22000 or other sets of specified FSMS requirements. It is also intended to be used as a criteria document by regulatory authorities and industry consortia which engage in direct recognition of certification bodies to certify that an FSMS complies with ISO 22000. Some of its requirements can also be useful to other parties involved in the conformity assessment of such certification bodies, and in the conformity assessment of bodies that undertake to certify the compliance of FSMS with criteria additional to, or other than, those in ISO 22000. FSMS certification does not attest to the safety or fitness of the products of an organization within the food chain. However, an FSMS requires an organization to meet all applicable food-safety-related statutory and regulatory requirements through its management system.

NOTE 3 Certification of an FSMS according to ISO 22000 is a management system certification, not a product certification. Other FSMS users can use the concepts and requirements of this document provided that the requirements are adapted as necessary.